The hole on the diagram is where I think it would say to wire line 4 and 5 together.ġ) Motor: wire 3,8,2 - to wire nut wire 1 to switch wire 4,5 to wire nut and to switch (see photo Baldor C元507 High Voltage Diagram.jpg their are two, one photo is crap, the other good.) I have attached pictures.Ĭould someone kindly give me some assistance and indicate what wires go where on the switch? the Baldor info plate has a hole in the high voltage diagram so I am only 98% sure I have the wiring to the motor figured out. I also want to get rid of the overload thingy and have my 220 line go directly to the switch and the switch go directly to the motor. I came across a 3/4 hp Baldor C元507 motor, same rpm and shaft size so I want to put that on. It works, however, the overload thingy gets overloaded with very little load and therefore is really limiting the usefulness of the bandsaw. I purchased a B300 fuse thingy for the overload thingy. I swapped out the 3 phase 1/2 hp motor for a single phase 1/2 motor wired at 240 a while ago. Originally it was 3 phase and has a switch which goes into an overload thingy ( sorry for the technical term ) and then to the motor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |